how to install wall to wall carpet::Start by removing the moldings around the floor and take the door off the entrance, so you can get the old carpet out and the new carpet in easier how to install wall to wall carpet

how to install wall to wall carpet

how to install wall to wall carpet

how to install wall to wall carpet::Start by removing the moldings around the floor and take the door off the entrance, so you can get the old carpet out and the new carpet in easier.
Do not remove the tackstrips and make sure the floor is clean and dry.
Install new tackless strips if it is new construction or you are going over hardwood floor or vinyl around the perimeter of the room, but not in front of doorways.
Put the underpad down in strips that butt up to or reach the tackless strips.
Trim the excess underlay along the inside of the tackless strip and use duct tape to seal the seams.
A small bead of glue can be used on concrete floors to hold the pad in place.
To install carpet properly, you need to start with a piece that overlaps the edge of the floor by 4 to 6 inches.
The overlay can then be trimmed so the carpet fits properly.
To cut your first section, measure the room at its longest point and add 6 inches to that measurement.
Mark the back of your carpet on both edges with that measurement and join the two marks with a chalk line.
Be sure to place a piece of scrap board underneath your cut line to protect the underlying carpet.
Be sure the carpet pile is running the same way in both pieces, and that the carpet piece is large enough to overlap the wall by 4 to 6 inches, as well as overlapping the first piece of carpet by 4 to 6 inches.
After cutting the carpet, center a piece of seaming tape on the floor underneath where they join, adhesive side up.
Use a knee kicker to attach the carpet along one edge.
This will stretch the carpet over the tackless strip where the tacks will grab it and hold it firmly in place.
A carpet stretcher will finish attaching the carpet.
A carpet stretcher is similar to knee kicker, but much longer.
Put one end of the carpet stretcher against the wall where the carpet is already attached and place the other end about 6 inches from the far wall.
The carpet stretcher also has teeth to grip the carpet, and when you push on the activation lever, it will stretch the carpet over the tackless strip near the far wall.
Work your way around the room stretching the carpet over the tackless strips, and trim the carper near the wall with a utility knife or a wall trimmer.
Using a stair tool, tuck the carpet down into the gap between the tackless strips and the wall.
At the doorway, trim the carpet so the edge is centered under the closed door and install a door edge strip.
Finally, cut any vent openings and install the molding on the baseboards.
Stretch your back, check to see if your knees still work, and then take some time to admire what all your hard work has accomplished.
how to install wall to wall carpet::Carpeting will also reduce echoes
and create a safer play environment for children how to install wall to
wall carpet